Simpson Strong-tie
4" x 4" Galvanized Elevated Post Base
32.99
Features
- Hole drilled into post for adjustability
- For uplift loads, epoxy or cast-in-place is required
- Can be used to secure 4" x 4" wood posts to either pier blocks or cast-in-place concrete
- Material: 12 guage base, threaded rod support 3/4" x 6", nut and washer are shipped assembled
- Finish: base is hot-dip galvanized, threaded rod is zinc plate
- Dimensional connector
- Secured with epoxy: drill a 7/8" diameter hole 4" deep minimum and fill the hole halfway with SET epoxy or drill a 13/16" diameter hole 4" deep minimum and fill the hole halfway with AT adhesive
- Insert and adjust to the desired height
- The threaded rod should be embedded a minimum of 3- 1/2"
- Minimum sidecover is 3" from the center of the threaded rod for both products
- Supported by a nut: drill a 1" diameter hole 3-1/2" deep minimum
- Insert and adjust to the desired height
- Embedded in wet concrete: embed 5/8" rod minimum 4" embedment
- Minimum sidecover is 3" from the center of the threaded rod
- Fully engage at least three threads in the base
- Post bases DO NOT provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top supported installations (such as fences or unbraced carports)
- Adjustable when installing
Specifications
- Item Number
- 2649745
- Unit of Measurement
- EA
- Assembled Length
- 4"
- Assembled Width
- 4"